Formation of Aluminum Oxide Films on Silicon Surface by Aluminum Evaporation in Oxygen Gas Atmosphere

Autor: Shinya Yoshidomi, Masahiko Hasumi, Y. Nagatomi, Toshiyuki Sameshima, Atsushi Kohno
Rok vydání: 2012
Předmět:
Zdroj: MRS Proceedings. 1426:421-426
ISSN: 1946-4274
0272-9172
DOI: 10.1557/opl.2012.868
Popis: We report formation of thin aluminum oxide AlOx films on the silicon surface by a simple method of Al metal evaporation in oxygen gas atmosphere. 520 μm thick 30-Ωcm p-type-silicon substrates with a top bare surface and a rear surface coated with 100 nm thick thermally grown SiO2 layers were prepared. AlOx films were formed on the top surfaces by Al metal evaporation up to 20 s in oxygen gas atmosphere at 0.8 Pa with a flow rate of 3 sccm. Samples were subsequently annealed with 9.0x105 Pa H2O vapor at 260°C for 3 h. Measurement of capacitance response to a modulation voltage at 500 kHz as a function of bias gate voltages C-V revealed that AlOx films had the effective oxide thickness ranging from 2.0 and 2.6 nm were formed. C-V measurements also revealed that negative fixed charges were accumulated with a density of 5x1012 cm-2 in AlOx films. Photo-induced carrier microwave absorption measurement resulted in a high minority carrier effective lifetime τeff of 3.6x10-4 s comparable to that of 4.1x10-4 s for thermally grown SiO2 passivation. Field effect passivation was probably caused by negative charges in AlOx so that the surface recombination velocity decreased to 70 cm/s. X-ray reflectivity analysis indicated that the interfacial layer like SiOx was formed between AlOx and Si substrate. High pressure H2O vapor heat annealing caused increase in the density and decrease in the thickness of AlOx layers, although it increased the density and thickness of the interfacial SiOx layer thickness. H2O vapor treatment is effective to improve the quality of nanometer thick AlOxlayer.
Databáze: OpenAIRE
Externí odkaz: