Multi-response Optimization in Machining Inconel-625 by Abrasive Water Jet Machining Process Using WASPAS and MOORA

Autor: G. Suresh Kumar, V. Satish Kumar, P. Venkateshwar Reddy
Rok vydání: 2020
Předmět:
Zdroj: Arabian Journal for Science and Engineering. 45:9843-9857
ISSN: 2191-4281
2193-567X
Popis: Certain materials that are used in industries to manufacture parts, components and sub-assemblies are difficult to machine using traditional machining processes. Abrasive water jet machining is a viable solution to such a problem, and its use is sought where precision is the requirement. The process involves many input controllable parameters that influence the performance characteristics of the process such as MRR, surface finish and kerf width. Inconel-625 is one such hard-to-machine material that finds many applications in industries. The objective of the present work is set to ascertain experimentally the influence of three input parameters on the three responses mentioned above through ANOVA. WASPAS and MOORA are two powerful techniques that are used for multi-objective optimization, and the ranks of both the MCDM methods were observed to be same. Traverse speed and abrasive mass flow rate are proven to be statistically significant on MRR and surface finish, whereas standoff distance along with the above two parameters is also significant on the response kerf width. Machined surface morphology is studied using scanning electron microscopy. From the SEM morphology, it was confirmed that the higher abrasive flow rate obtained rough surface finish.
Databáze: OpenAIRE
Externí odkaz:
Nepřihlášeným uživatelům se plný text nezobrazuje