New process solutions in the manufacture of thermochemically resistant ceramic molds for casting titanium alloys
| Autor: | V. K. Dubrovin, B. A. Kulakov, A. V. Karpinskii, O. M. Zaslavskaia |
|---|---|
| Rok vydání: | 2022 |
| Předmět: | |
| Zdroj: | Izvestiya Vuzov. Tsvetnaya Metallurgiya (Universities' Proceedings Non-Ferrous Metallurgy). :55-65 |
| ISSN: | 2412-8783 0021-3438 |
| DOI: | 10.17073/0021-3438-2022-5-55-65 |
| Popis: | The paper provides the results of studies on interaction between titanium melts and silica-containing investment molds. Pure silicon, compounds of titanium oxides and silicides were detected by X-ray diffraction analysis in the contact zone. The problem of the negative impact exerted by the mold on the casting is solved by using thermally stable and chemically resistant monocorundum molds based on an alumina sol binder. A refractory suspension was developed for investment casting containing special additives to improve wax mold wetting with the suspension, and to increase the mold shell strength. The article studies sedimentation properties of suspension. A method was developed for accelerated curing of sequentially applied refractory suspension layers by vacuum drying and subsequent chemical curing with a gaseous reagent. The formation time is reduced from 3–5 h to 20–30 min per layer. Comparative studies of kinetics of alumina sol binder convective drying and vacuum dehydration were conducted. The process of moisture removal per unit surface of the applied refractory layer in a vacuum of 5–10 kPa increases by 2–6 times. X-ray phase analysis was used to study the alumina sol conversion during high-temperature heating. The solid gel of the α-Al2O3 stable phase is obtained in the alumina sol mold shell when the calcination temperature rises to 1300–1350 °C with a sufficient strength of 9–12 MPa provided by sintering additives added to the suspension. Recommendations are given for additional protection of refractory ceramic layers after vacuuming and drying: treatment of the last layer with gaseous curing agents and application of a polyvinylacetal solution with a density of 1100–1200 kg/m3. The process solutions proposed will make it possible to increase both the efficiency of titanium alloy forming and casting processes and the quality of castings. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|