| Autor: |
Mooers, R. D., Cherry, M. R., Knopp, J. S., Aldrin, J. C., Sabbagh, H. A., Boehnlein, T. R. |
| Předmět: |
|
| Zdroj: |
AIP Conference Proceedings; 6/23/2011, Vol. 1335 Issue 1, p349-356, 8p, 1 Color Photograph, 1 Diagram, 3 Charts, 2 Graphs |
| Abstrakt: |
This paper presents results of an eddy current model validation study. Precise measurements were made using an impedance analyzer to investigate changes in impedance due to Electrical Discharge Machining (EDM) notches in aluminum plates. Each plate contained one EDM notch at an angle of 0, 10, 20, or 30 degrees from the normal of the plate surface. Measurements were made with the eddy current probe both scanning parallel and perpendicular to the notch length. The experimental response from the vertical and oblique notches will be reported and compared to results from different numerical simulation codes. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
