| Autor: |
Cui, Feng, Sun, Jingxuan, Lai, Xingping, Jia, Chong, Zhang, Suilin |
| Předmět: |
|
| Zdroj: |
Applied Sciences (2076-3417); Nov2023, Vol. 13 Issue 21, p11809, 20p |
| Abstrakt: |
This study aims at the problems of the difficulty in controlling the stability of the surrounding rock and the high-impact danger of knife handle-type working face mining. We take the I010206 working face of Kuangou Coal Mine in Xinjiang as the engineering background, establish the mechanical model of roof periodic fracture and the FLAC3D numerical model of a working face, and analyze the evolution characteristics of the surrounding rock stress and energy when the working face is widened, revealing the mechanism of induced impact caused by overburden fracture in the working face, putting forward the technology of hydraulic fracturing to relieve the danger in the roof area, and comparing the pressure relief effect. The research results show the following: (1) After the working face is widened, the overlying strata load is transferred to the coal seam in front of the working face and the upper and lower sides of the working face. after mining; the abutment pressure of the I010408 working face in the B4-1 coal seam is superimposed with the abutment pressure of the I010206 working face in the B2 coal seam, the stress concentration is higher, and the lateral support pressure of the goaf forms a high static load. The large-area roof caving forms a high dynamic load. All of them are more likely to induce rockburst. (2) In knife handle-type working face mining, the peak value of the advanced abutment pressure in working faces first decreases and then increases, and the advanced abutment pressure increases from 10.31 MPa to 14.62 MPa; the peak value and concentration degree of strain energy density increase with the increase in working face width. (3) Measures were proposed to weaken the hydraulic fracturing roof in advance. After using hydraulic fracturing technology, the pressure step distance of the working surface roof was reduced, and the microseismic energy frequency was significantly reduced. These measures reduced the impact risk of the working face and ensured the safe mining of the working face. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
