| Autor: |
Potnik V; Biomedical Engineering Unit, Department of Industrial Engineering, University of Florence, 50121 Florence, Italy., Frediani G; Biomedical Engineering Unit, Department of Industrial Engineering, University of Florence, 50121 Florence, Italy., Carpi F; Biomedical Engineering Unit, Department of Industrial Engineering, University of Florence, 50121 Florence, Italy.; IRCCS Fondazione don Carlo Gnocchi ONLUS, 50143 Florence, Italy. |
| Jazyk: |
angličtina |
| Zdroj: |
Biomimetics (Basel, Switzerland) [Biomimetics (Basel)] 2024 Mar 15; Vol. 9 (3). Date of Electronic Publication: 2024 Mar 15. |
| DOI: |
10.3390/biomimetics9030177 |
| Abstrakt: |
Wearable mechatronics for powered orthoses, exoskeletons and prostheses require improved soft actuation systems acting as 'artificial muscles' that are capable of large strains, high stresses, fast response and self-sensing and that show electrically safe operation, low specific weight and large compliance. Among the diversity of soft actuation technologies under investigation, pneumatic devices have been the focus, during the last couple of decades, of renewed interest as an intrinsically soft artificial muscle technology, due to technological advances stimulated by applications in soft robotics. As of today, quite a few solutions are available to endow a pneumatic soft device with linear actuation and self-sensing ability, while also easily achieving these features with off-the-shelf materials and low-cost fabrication processes. Here, we describe a simple process to make self-sensing pneumatic actuators, which may be used as 'inverse artificial muscles', as, upon pressurisation, they elongate instead of contracting. They are made of an elastomeric tube surrounded by a plastic coil, which constrains radial expansions. As a novelty relative to the state of the art, the self-sensing ability was obtained with a piezoresistive stretch sensor shaped as a conductive elastomeric body along the tube's central axis. Moreover, we detail, also by means of video clips, a step-by-step manufacturing process, which uses off-the-shelf materials and simple procedures, so as to facilitate reproducibility. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
