Zobrazeno 1 - 10
of 4 152
pro vyhledávání: '"Wound rotor motor"'
Publikováno v:
IEEE Transactions on Transportation Electrification. 8:4569-4582
Accurate and timely fault diagnosis of the rotating rectifier for a wound-rotor synchronous starter/generator is of great importance to improve system reliability. In the generation mode of the system, there is one idle stator winding of the main exc
Publikováno v:
Gong-kuang zidonghua, Vol 44, Iss 8, Pp 81-86 (2018)
In view of problems of technical difficulties, high cost and high voltage requirements for power electronic components in current high voltage wound-rotor motor using stator-side high voltage inverter for frequency conversion speed regulation, a roto
Externí odkaz:
https://doaj.org/article/fed9faf833824fdfb60ca01150afbd28
Publikováno v:
IEEE Transactions on Industrial Electronics. 69:8463-8471
Wound rotor induction motors (WRIM) are widely used in a vast number of high output power industrial applications due to their capability of reaching high start torques while maintaining low inrush currents. Nonetheless, these machines are very prone
Publikováno v:
IEEE Transactions on Industrial Electronics. 69:7720-7732
The brushless doubly fed motor (BDFM) shows great potential for use in large medium-voltage adjustable-speed drive (ASD) systems due to its high reliability and cost benefits of a partially rated low-voltage power electronics converter. However, unde
Publikováno v:
IEEE Transactions on Industrial Electronics. 69:5453-5464
Wound Rotor Induction Machine (WRIM) connected to stator and rotor Voltage Source Converters (VSCs), known as the Double-Inverter-fed WRIM drive, can be viewed as two virtual Squirrel Cage Induction Machine (SQIM) drives, when seen from air-gap. In t
Autor:
Fateme Zare, Zahra Nasiri-Gheidari
Publikováno v:
IEEE Transactions on Transportation Electrification. 8:2062-2069
Two-Degree-of-Freedom (2-DOF) electrical machines require position sensors for their motion control. In comparison with using two independent sensors, using a 2-DOF sensor enhances closed-loop control system’s performance. However, due to 3-D struc
Slotless Disk Type Resolver: A Solution to Improve the Accuracy of Multi-Speed Wound Rotor Resolvers
Publikováno v:
IEEE Transactions on Transportation Electrification. 8:1493-1500
Publikováno v:
IEEE/ASME Transactions on Mechatronics. 27:493-500
Multi-speed resolvers are used in the applications that need higher accuracy. However, they suffer from losing absolute position information. To overcome this challenge and improve the reliability of detecting position, using multi-turn resolvers is
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 71:1-11
One of the major challenges of diagnosing rotor symmetry faults in induction machines is severe modulation of fault and supply frequency components. In particular, existing techniques are not able to identify fault components in the case of low slips
Publikováno v:
IEEE Transactions on Power Electronics. 36:13423-13433
Fault detection of a rotating rectifier for a wound-rotor synchronous starter/generator (WRSSG) without a rotor position sensor in the stationary state is necessary for a successful engine start. Based on high-frequency (HF) voltage injection, a nove