Zobrazeno 1 - 10
of 18
pro vyhledávání: '"Vladimir Dokichev"'
Publikováno v:
Materials Science Forum. 1049:117-123
Carbon fibers have been TiO2 coated. Previously, the carbon fiber surface has been heat-treated to remove the sizing. The TiO2 layer has been formed on the fiber surface using the sol-gel technique by immersion in a solution. After coating, the sampl
Autor:
Vladimir Dokichev
Publikováno v:
ChemChemTech. 65:92-100
Autor:
Vladimir Dokichev, Alexander Voloshin
Publikováno v:
SOCAR Proceedings. :116-124
The influence of the electromagnetic field (EMF) on the corrosion of structural carbon steel in a 3% aqueous solution of sodium chloride in the presence of CO2 was studied. It is shown that the EMF increases the corrosion rate of steel by 1.13 times
Autor:
Vladimir Dokichev
Publikováno v:
SOCAR Proceedings. :95-104
The mineralogical, chemical and gravimetric composition of drill cuttings formed during the construction of wells in the Vinno-Bannovskoye oil field in the Samara region has been studied. It was found that the cuttings included in the drill cuttings
Autor:
Vladimir Dokichev, Alexander Voloshin
Publikováno v:
SOCAR Proceedings. :33-40
The thermobaric conditions for the formation of gas hydrates in the presence of the sodium salt of carboxymethylcellulose, dextran, and arabinogalactan were studied in a quasi-equilibrium thermodynamic experiment. It is established that polysaccharid
Publikováno v:
Materials Today: Proceedings. 38:1584-1587
Studies of SiO2 films deposited on the surface of carbon fibers from a PAN precursor were carried out. Sol-gel solutions with different H2O/TEOS molar ratios were obtained and studied. The hydrolysis-condensation reaction in a sol–gel solution lead
Publikováno v:
PROCEEDINGS OF THE II INTERNATIONAL CONFERENCE ON ADVANCES IN MATERIALS, SYSTEMS AND TECHNOLOGIES: (CAMSTech-II 2021).
Publikováno v:
MATEC Web of Conferences. 376:01002
The paper describes the modification conducted for the PAN carbon fiber surfaces in the solutions of nitric and sulphuric acids. The authors studied the impact of modification parameters such as temperature, acid concentration, time and ratio of the
Publikováno v:
Solid State Phenomena. 284:1242-1247
The article shows the possibility of applying a silicon dioxide coating on the carbon fiber by the sol-gel method. The evaluation of the protective properties of the obtained coatings at a temperature of 600 ° C is given; the changing of the a coate
Publikováno v:
MATEC Web of Conferences, Vol 315, p 05001 (2020)
In this study to apply an oxide film to the surface of carbon fibers a sol-gel solution was used. Sol-gel solutions were prepared according to the described procedure from tetraethoxysilane (TEOS) and ethanol at various H2O concentrations. The molar