Zobrazeno 1 - 10
of 40
pro vyhledávání: '"Seiji Yoneda"'
Publikováno v:
岐阜経済大学論集 The Journal of Gifu Keizai University. 33(1):277-282
米田清治教授記念号
In Commemoration of Prof. Seiji Yoneda
In Commemoration of Prof. Seiji Yoneda
Publikováno v:
The Journal of Japan Institute of Navigation. 137:81-89
Publikováno v:
Journal of Electronic Materials. 45:1767-1771
A method is proposed to reduce the production cost of power generation thermoelectric modules. FeSi2 is employed as the thermoelectric material because of its low cost, low environmental load, and oxidation resistance. The raw materials were prepared
Autor:
Seiji Yoneda, Y. Ohno
Publikováno v:
JOURNAL OF ADVANCES IN PHYSICS. 5:742-751
Experimental studies on the behavior of a Polymer Electrolyte Fuel Cell (PEFC) stack were conducted by performing complex impedance measurements. Initially, the steady state characteristics of a 10-cell stack were measured, and the power function of
Autor:
Seiji, Yoneda
Publikováno v:
熊本大学社会文化研究. 9:261-279
In Japan, the big merger of municipalities was help three times from 1880's to now. The first big merger was in Meiji Era, the second big merger was in Showa Era and third big merger was in Heisei Era as 2000's. This paper deals with the merger polic
Autor:
Arunkumar Bommannavar, Seiji Yoneda, Ravhi S. Kumar, Mahalingam Balasubramanian, Mercouri G. Kanatzidis, Andrew Cornelius, Matthew Jacobsen
Publikováno v:
Journal of Electronic Materials. 39:1828-1831
The high-figure-of-merit thermoelectric material AgPb18SbTe20 has been investigated by in situ angular-dispersive x-ray diffraction (XRD) and x-ray absorption fine-structure (XAFS) measurements up to 30 GPa. Resistivity and thermopower were measured
Autor:
Ichiro Shiota, Yoshikazu Shinohara, Seiji Yoneda, Isao J. Ohsugi, Hiromasa T. Kaibe, Isao Nishida, Y. Ohno, Nobuhiro Yuhashi, Eiji Ohta
Publikováno v:
IEEJ Transactions on Fundamentals and Materials. 124:312-316
The p-type Ag0.208Sb0.275Te0.517 boule was unidirectionally grown using a Bridgman furnace and, it was subsequently cooled rapidly by an Ar flush to form a high temperature phase AgSbTe2, which could be desirable for power generation. Though the boul
Publikováno v:
MATERIALS TRANSACTIONS. 42:329-335
Sintered PbTe materials with average grain sizes of 28-309 μm were prepared by the spark plasma sintering technique. The apparent densities of the sintered PbTe were 8.17-8.23 Mg/m 3 , which were higher than 99% of the theoretical one. Thermoelectri
Autor:
Masato Noto, Seiji Yoneda
Publikováno v:
International Journal on Smart Sensing & Intelligent Systems; Sep2013, Vol. 6 Issue 4, p1533-1558, 26p
Publikováno v:
Journal of Crystal Growth. 204:229-232
A physical vapor transport technique was performed to grow an n-type PbTe single crystal heavily doped with PbI 2 . The boules obtained repeatedly by this transport were hemispheres with a dimension of 19 mm in diameter. Laue back-reflection techniqu