Zobrazeno 1 - 10
of 50
pro vyhledávání: '"O. Perevertov"'
Publikováno v:
AIP Advances, Vol 6, Iss 5, Pp 056208-056208-6 (2016)
The complexity of Ni-Mn-Ga single crystal originates from the interplay between ferromagnetic domain structure and ferroelastic twinned microstructure. Magnetic domain structure in the vicinity of single twin boundary was studied using magneto-optica
Externí odkaz:
https://doaj.org/article/91e167424ba24d35b0da4ce720441eb0
Publikováno v:
NDT & E International. 87:15-23
Hard milling was applied to 100Cr6 steel of 50 HRC hardness using cutting tools with different flank wear. The modified surface layers were investigated by eddy current and incremental permeance measurements at magnetizing frequencies from 0.2 to 10
Autor:
O. Perevertov
Publikováno v:
Journal of Magnetism and Magnetic Materials. 428:223-228
The influence of applied elastic tensile stress up to 120 MPa and compressive stress up to 35 MPa on the magnetic hysteresis curves of non-oriented Fe-3%Si steel is studied. In two tensile stress ranges the hysteresis loop changed monotonously – lo
Publikováno v:
Journal of Magnetism and Magnetic Materials. 426:685-690
Magneto-acoustic emission (MAE) in a grain-oriented electrical steel is measured in a wide range of the magnetizing frequencies f mag = 0.5 − 100 Hz at the controllable sinusoidal/triangular waveforms of the magnetic induction B(t). Magnetic field
Publikováno v:
Journal of Magnetism and Magnetic Materials. 410:198-209
The potential of the magnetic Barkhausen noise method for a non-destructive evaluation of the steel surface damage cased by milling was comprehensively investigated. A typical bearing steel was heat treated to three different hardnesses and then mach
Publikováno v:
Journal of Magnetism and Magnetic Materials. 385:358-367
The effect of an elastic applied tensile stress on the quasistatic hysteresis curve and domain structure in conventional (110) [001] Fe-3%Si steel, cut transversely to the rolling direction, is studied. The magnetic domains and magnetization processe
Publikováno v:
NDT & E International. 44:490-494
Surface decarburization of steel was non-destructively and quantitatively investigated by magnetic hysteresis. Flat samples were prepared from spring steel 54SiCr6 and decarburized layers of different thickness were produced on their surfaces by anne
Publikováno v:
Journal of Magnetism and Magnetic Materials. 323:1692-1697
Industrially unfavorable process of steel surface decarburization was induced by annealing in air. Two methods of after-anneal surface treatment were used: an acid pickling and a sand blasting. The obtained decarburized layers were examined by optica
Publikováno v:
IEEE Transactions on Magnetics. 46:517-520
In this work the potential of the Barkhausen noise technique for testing of the magnetic properties of electrical steels was studied. Different grades of nonoriented and grain oriented steels were tested in the quasi-static magnetization regime. A ve
Autor:
O Perevertov
Publikováno v:
Journal of Physics D: Applied Physics. 40:949-954
The influence of residual stress on the hysteresis properties of mild steel is studied in detail. Magnetic measurements were done in different directions to investigate the stress-induced anisotropy. The hysteresis loops measured in any fixed directi