Zobrazeno 1 - 10
of 19
pro vyhledávání: '"Miyagawa Masaru"'
Autor:
Junichi Sato, Kinoshita Susumu, Mitsutaka Homma, Toshio Shimizu, Miyagawa Masaru, Sakaguchi Osamu
Publikováno v:
IEEJ Transactions on Power and Energy. 128:1431-1438
SF6 gas is widely employed in medium-voltage switchgear because of its high insulation reliability and down-sizing ability. However, SF6 gas was placed on the list of greenhouse gases under the Kyoto Protocol in 1997. Since then, research on low-SF6
Publikováno v:
IEEE Transactions on Dielectrics and Electrical Insulation. 6:486-490
This paper describes insulation technology for 72/84 kV vacuum interrupter for a new cubicle-type gas insulated switchgear (CGIS). The insulation performance has been increased significantly by a multi-gap shield configuration around the ceramic surf
Publikováno v:
IEEJ Transactions on Power and Energy. 116:1279-1284
Publikováno v:
IEEJ Transactions on Power and Energy. 113:1323-1328
Publikováno v:
Electrical Engineering in Japan. 111:60-67
Generally, it is known that insertion of a barrier under a nonuniform field in air increases the flashover voltage. This is called the barrier effect. However, there are many uncertainties that remain to be clarified about the barrier effect in SF6 g
Publikováno v:
IEEJ Transactions on Power and Energy. 110:348-356
The breakdown characteristics using a hemispherical tip rod (10 ∼ 60 mm) molded with epoxy resin-to-plate gap in SF6 gas up to 0.20 MPa was studied. The result shows that breakdown characteristics are classified into three regions (A, B and C regio
Publikováno v:
IEEJ Transactions on Power and Energy. 110:1006-1012
Autor:
Mitsutaka Homma, Tetsu Shioiri, Tamon Ozaki, J. Sato, Katsumi Suzuki, Sakaguchi Osamu, Miyagawa Masaru, T. Kamikawaji
Publikováno v:
2003 Annual Report Conference on Electrical Insulation and Dielectric Phenomena.
The authors have developed solid insulated switchgear that does not use SF/sub 6/ gas at all as an insulating medium. This paper describes the insulating material technology, diagnostic technology for partial discharge, insulation technology of the v
Autor:
Kinoshita Susumu, J. Sato, Miyagawa Masaru, Sakaguchi Osamu, Satoshi Makishima, M. Homma, E. Kaneko, N. Kubota, T. Yoshida, T. Shioiri
Publikováno v:
IEEE/PES Transmission and Distribution Conference and Exhibition.
This paper describes epoxy casting, insulation and operating mechanism technologies applied to newly developed solid insulated switchgear (SIS). The main insulating material is epoxy resin of high toughness and high thermal-resistance. This resin inc
Akademický článek
Tento výsledek nelze pro nepřihlášené uživatele zobrazit.
K zobrazení výsledku je třeba se přihlásit.
K zobrazení výsledku je třeba se přihlásit.