Zobrazeno 1 - 10
of 34
pro vyhledávání: '"Karl-Erik Rydler"'
Autor:
Michal Grzenik, Torsten Lippert, Bruno Trinchera, Marian Kampik, Valter Tarasso, Karl-Erik Rydler
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 70:1-8
This article presents results of a comparison of a traveling ac voltage standard, which was a fused-silica planar multijunction thin-film thermal converter (PMJTC) developed at the National Institute of Standards and Technology (NIST). The ac–dc vo
Autor:
Tobias Bergsten, Karl-Erik Rydler
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 68:2041-2046
This paper presents a simplified method for realizing absolute phase and ac resistance for current shunts using only impedance ratio measurements. The method is based on three geometrically identical current shunts with different resistances, but wit
Publikováno v:
2018 Conference on Precision Electromagnetic Measurements (CPEM 2018).
This paper describes a method for realisation of inductance and quality factor to high frequencies by determining the frequency response of gain-and phase-error of an inductance meter using two coils made of a single copper wire. As a starting point
Publikováno v:
2018 Conference on Precision Electromagnetic Measurements (CPEM 2018).
The paper presents results of a trilateral comparison of a travelling AC voltage standard, which was a fused-silica NIST planar multijunction thin-film thermal converter. The AC-DC voltage transfer difference of the standard was measured at 2 V and s
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 64:1559-1563
We present the design and electrical characteristics of an active low-pass filter. It will be used in a reference waveform source based on a programmable Josephson voltage standard with multilevel delta–sigma modulation to generate accurate and spe
Autor:
Karl-Erik Rydler, Jiri Streit, Ove Gunnarsson, Laurie Christian, M.D. Early, Bengt-Olof Andersson, Martin Šíra
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 62:1600-1607
We report on the performance of a simple method, known as the reference step method, to build up the dc voltage scale of a source. The key advantages of this method are that it relies on equipment that is readily available in most high-level laborato
Publikováno v:
2016 Conference on Precision Electromagnetic Measurements (CPEM 2016).
We describe a low frequency Josephson impedance bridge and the measurement methods. The bridge is useable below 400 Hz and is based on two programmable Josephson voltage standards. Measurements of 1:1, 1:2 and 1:10 capacitance ratio have been perform
Publikováno v:
2016 Conference on Precision Electromagnetic Measurements (CPEM 2016).
The Digital Sampling Wattmeter of SP has been upgraded. New resistive shunts and dividers are built, with lower temperature coefficient and less power dependence. The aperture time of the samplers are increased. The calibration methods are also upgra
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 60:2341-2346
We present a new source for currents in the picoampere range based on the charging of a capacitor at a constant rate. The voltage ramp is generated using Delta-Sigma modulation and low-pass filtering. This method ensures the linearity of the voltage
Publikováno v:
IEEE Transactions on Instrumentation and Measurement. 60:2399-2403
This paper describes high-accuracy low-frequency ac voltage measurements using a programmable Josephson voltage standard based on a binary Josephson array. AC voltage synthesis is performed by switching between quantized Josephson voltages. The accur