Zobrazeno 1 - 10
of 120
pro vyhledávání: '"Junguo Xu"'
Publikováno v:
Tribology Online, Vol 2, Iss 2, Pp 59-63 (2007)
We have developed a simulation method in which grooves are virtually distributed on a slider air-bearing surface instead of on a grooved medium surface and used it to investigate slider flying performance. The characteristics of miniaturized air-bear
Externí odkaz:
https://doaj.org/article/ac84bb2d536e44a29a92952e7e4a7d77
Autor:
Junguo Xu, Yuki Shimizu, Yuichi Aoki, Hidekazu Kohira, Yuichiro Sano, Jianhua Li, Kenji Kuroki, Hiroyuki Matsumoto, Masaru Furukawa, Toshiya Shiramatsu
Publikováno v:
IEEE Transactions on Magnetics. 50:114-118
The fundamental performance of contact/clearance sensor, namely embedded contact sensor (ECS), is addressed in this paper. Both simulation and experiment results revealed that ECS is a promising sensor for low clearance and high reliability at subnan
Publikováno v:
Microsystem Technologies. 19:1607-1614
A typical thermal-contact sensor (TCS) used in hard-disk drives was investigated by the simulation. Analytical solution to solve temperature variation of sensor due to frictional heat was built to estimate the sensor temperature rise under variable h
Publikováno v:
Microsystem Technologies. 19:1441-1448
The keep increasing areal density in hard disk drive demands reducing the clearance between the read/write element and the disk surface. A clearance of 2 nm could be achieved using thermal-flying-height technology (Kurita et al. IEEE Trans Magn 41(5)
Autor:
Haruaki Otsuki, Jin Liu, Junguo Xu, Jianhua Li, Shoya Nosaki, Kenji Suzuki, Masaru Furukawa, Kyosuke Ono
Publikováno v:
Microsystem Technologies. 18:1383-1388
We have developed an actuator with a heater embedded in the head slider. This actuator, called the thermal positioning control (TPC) actuator, is integrated next to the read write elements in the head slider. By applying electric power to the TPC act
Publikováno v:
Microsystem Technologies. 18:1583-1589
Flying height control (TFC) sliders with thermal actuation, which make it possible to control head disk spacing, have been introduced in commercial products for compensating the flying height loss and reducing the risk of head disk contacts, thus to
Publikováno v:
Microsystem Technologies. 18:1597-1606
Aiming at improvements of both stability of slider flying and magnetic-recording performance under a low-clearance condition, a “narrow-grooved slider” was constructed and demonstrated at drive level. The proposed slider has narrow grooves on its
Autor:
Masaru Furukawa, Toshiya Shiramatsu, Yuki Shimizu, Junguo Xu, Masayuki Kurita, Hidekazu Kohira
Publikováno v:
IEEE Transactions on Magnetics. 47:3426-3432
Targeting both higher touchdown sensitivity and highly accurate nanometer-scale defect detection on a disk surface, a thermal-contact sensor, integrated into a magnetic-head slider, was developed. It was experimentally shown that the contact sensor h
Publikováno v:
IEEE Transactions on Magnetics. 47:1817-1822
Study of lubricant-coated sliders showed that low slider surface energy increases in stable slider flying and reduces lubricant droplet formation on the disk surface at ultra-narrow clearance. Both component- and drive-level evaluation showed the lub
Publikováno v:
Microsystem Technologies. 17:1051-1056
The mechanism of head-disk-clearance change due to a humidity effect was investigated experimentally. The head-disk clearance was measured by moving the head elements towards the disk by thermal flying-height-control technology until the head touched