Zobrazeno 1 - 10
of 19
pro vyhledávání: '"John C. Shyne"'
Publikováno v:
Journal of Performance of Constructed Facilities. 5:220-222
Publikováno v:
Journal of Performance of Constructed Facilities. 1:168-187
The paper describes the analysis of failures of a 108‐in. (2.74 m) diameter steel pipe water main. Total pipe separations occurred because of large unrelieved thermal stresses and stress amplification caused by the eccentricity of the welded bell
Publikováno v:
Journal of Materials Science. 12:131-140
Mechanical behaviour of particulate composites of cadmium containing 0.6 to 3 μm size particles of boron and tungsten (up to 30 vol %) were studied from −196 to 260° C (0.13 to 0.9Tm). The marked strengthening of cadmium by the presence of fine p
Autor:
John C. Shyne, Alfred Goldberg
Publikováno v:
Journal of Nuclear Materials. 60:137-144
Thermodynamic arguments are presented about the effect of hydrostatic pressure and uniaxial stress on the transformation of the δ-stabilized phase to the α phase in Pu alloys. Uniaxial compression, hydrostatic pressure, and uniaxial tension all pro
Publikováno v:
Metallurgical transactions. 5:1319-1324
Tension tests were performed on metastable austenitic Fe-Ni-C alloys to study the influence of martensite formed during straining on mechanical behavior. Although both stressassisted, plate martensite and fine, lathlike strain-induced martensite were
Autor:
G. R. Edwards, S. E. Hsu, D. Francois, John C. Shyne, I. C. Huseby, Terry R. McNelley, Oleg D. Sherby
Publikováno v:
Metallurgical Transactions A. 6:2005-2008
Initial and strain-aging yield points have been observed and studied for three hexagonal-based particulate composites: Cd-30 vol pct B, Mg-25 vol pct B, and Zn-15 vol pct A12O3. The strain-aging yield points begin to appear at 0.5 to 0.6Tm and persis
Publikováno v:
Metallurgical transactions. 5:1305-1318
A metallographic study was made of the martensite formed during plastic straining of metastable, austenitic Fe-Ni-C alloys withMs temperatures below 0°C. A comparison was made between this martensite and that formed during the deformation of two TRI
Publikováno v:
Metallography. 10:299-314
Morphologies resulting from the transformation of austenite to martensite during deformation of an Fe-21Ni-0.6C alloy are described. Samples were deformed either by conventional quasistatic tension loading, by high-strain-rate inertial tension loadin
Publikováno v:
Journal of Nuclear Materials. 55:33-52
The influence of elastic and plastic deformation on the transformation of the fcc δ phase in a Pu-1 at % Ga alloy was investigated. Undeformed, this phase could be retained without decomposition for over 17 months at 23°C. An M s at 8°C is indicat
Publikováno v:
Metallurgical Transactions. 2:2955-2958