Zobrazeno 1 - 10
of 44
pro vyhledávání: '"Himanshu J. Bahirat"'
Autor:
Rohit S. Thute, Himanshu J. Bahirat, Shrikrishna A. Khaparde, Piotr Lubicki, Shankar Kodle, Vikas Dabeer
Publikováno v:
IET Generation, Transmission & Distribution, Vol 13, Iss 10, Pp 1960-1969 (2019)
There is an increase in fault current levels seen by utilities due to grid expansion and the addition of new resources. Installation of superconducting fault current limiter (SCFCL) at transmission voltage levels is being explored to reduce the fault
Externí odkaz:
https://doaj.org/article/77e23854a3c64fe7b0740c12c87fe6a1
Publikováno v:
IEEE Transactions on Power Electronics. 38:7256-7270
Publikováno v:
IEEE Transactions on Industry Applications. 59:1077-1089
Autor:
Lokesh Dewangan, Himanshu J. Bahirat
Publikováno v:
IEEE Transactions on Power Delivery. 37:2337-2347
With the increase in number of VSC based HVDC systems, it is inevitable that there would be interconnections with weak ac grids. The paper presents the analytical basis for identifying coupling in the power loops which is dependent on grid inductance
Publikováno v:
2022 IEEE Energy Conversion Congress and Exposition (ECCE).
Publikováno v:
IET Power Electronics. 13:2943-2959
Electrical discharge machining (EDM) is a non-conventional machining technique that requires pulse generators to create sparks between the tool and the workpiece. Classical texts describe only two types of EDM pulse generators (EPGs), although there
Publikováno v:
IEEE Transactions on Plasma Science. 48:3350-3357
Pulse generators for wire electric discharge machining (WEDM) are derived from standard dc–dc converters. However, their design and analysis need to be done carefully by considering the pulsed nature of the load. In this article, these issues are d
Autor:
Lokesh Dewangan, Himanshu J. Bahirat
Publikováno v:
IEEE Transactions on Power Systems. 35:2835-2846
Using HVDC grids for interconnection of ac grids across countries posses questions regarding interactions and stability. Important aspects that may be considered are the different short circuit ratio (SCR) values of the corresponding ac grids and out
Autor:
Nitin Tiwari, S.V. Kulkarni, Himanshu J. Bahirat, Kamlesh Joshi, Suhas S. Joshi, Makarand M. Kane
Publikováno v:
Procedia CIRP. 95:296-301
Wire Electric Discharge Machining (WEDM) is being explored as an efficient alternative for cutting silicon wafers for photovoltaics. This is because WEDM results in lesser kerf loss as compared to traditional abrasive cutting techniques. While the co
Publikováno v:
Procedia CIRP. 95:302-307
Multi-Wire EDM (MWEDM) is being investigated for cutting silicon wafers from ingots in solar industry and IC manufacturing industry. However, practical realization of MWEDM is limited by the forces exerted on the wires. This paper explains nature of