Zobrazeno 1 - 10
of 17
pro vyhledávání: '"G. A. Cingara"'
Publikováno v:
Journal of Materials Science. 48:6689-6699
Nanocrystalline Ni and Ni–Fe alloys produced by electrodeposition were characterized using high-resolution transmission electron microscopy (HR-TEM) and X-ray diffraction (XRD). The grain sizes for these materials spanned a range of about 81–10 n
Publikováno v:
Metallurgical and Materials Transactions A. 40:3117-3127
Commercial dual-phase (DP) steel in sheet form and comprised of ferrite, martensite, and bainite was subjected to uniaxial tension up to fracture. The damage characteristics were studied through extensive quantitative metallography and scanning elect
Publikováno v:
Materials Science and Engineering: A. 516:7-16
The effect of martensite morphology and distribution in a ferrite matrix on the mechanical properties and the damage accumulation in uniaxial tension was investigated in two different automotive-grade dual phase DP600 steels. The two sheet steels had
Publikováno v:
Canadian Metallurgical Quarterly. 47:71-82
The terminology of strain induced or altered boundaries should reflect the mechanism that created them and the function they perform; both are related to the regions they surround or separate. Dislocation glide under applied stress is the primary mec
Publikováno v:
Metallurgical and Materials Transactions A. 37:2773-2786
The factors determining the temperature, heating rate, microstructure, and strain rate in Al 7075-T6 friction stir spot welds are investigated. Stir zone microstructure was examined using a combination of transmission electron microscopy (TEM) and el
Autor:
H.J. McQueen, G. Avramovic-Cingara
Publikováno v:
Materials Science Forum. :1659-1664
Specimens of commercial purity aluminum were subjected to a strain path change test during high temperature deformation. Specimens were deformed at 4000 C and strain rate of 0.1 s-1 up to various strains of 0.2, 0.5, and 1. Then in a strain path chan
Publikováno v:
Materials Science Forum. :1107-1112
The microstructural features of Al 5754 friction stir spot welds are investigated using transmission electron microscopy (TEM) and electron back-scattered diffraction (EBSD). It is shown that EBSD misorientation maps using a 2° misorientation criter
Publikováno v:
Journal of Materials Engineering and Performance. 14:179-187
The rates of transformation and the morphologies after full annealing and industrial rolling without reheating were determined to establish the degree of similarity. Steels with 0.1–1% C and almost nil to 17% alloying addition (M2 steel) were isoth
Publikováno v:
Canadian Metallurgical Quarterly. 43:193-202
The 2090 experimental alloy was deformed in torsion in the temperature (T) range of 300 through 500 °C at strain rates (e of 0.01 to 5 s-1. The results were analyzed using the equation A (sinh α σ)n = Z = e exp (QHW/RT) where Z is the Zener-Hollom
Publikováno v:
Materials Science and Technology. 19:11-19
Experimental alloy 2090 (Al – 2.1Li – 2.6Cu – 0.4Mn) was deformed in torsion and compression at temperatures T=300, 400, and 500°C and strain rates e=10–2 to 10 s–1. The torsion and compression results were analysed using equation A(sinh