Zobrazeno 1 - 10
of 30
pro vyhledávání: '"Fu, Lin"'
Publikováno v:
IEEE Transactions on Power Electronics. 30:7282-7298
This study mainly focuses on the development of an adaptive fuzzy-neural-network control (AFNNC) system for a single-stage boost inverter. First, the dynamic model of a single-stage boost inverter is analyzed and is built for the later control manipu
Publikováno v:
Journal of the Franklin Institute. 351:2755-2780
In this study, a total sliding-mode-based particle swarm optimization control (TSPSOC) scheme is designed for the periodic motion control of an indirect field-oriented linear induction motor (LIM) drive. First, an indirect field-oriented mechanism fo
Autor:
Shao-Ming He, De-Fu Lin
Publikováno v:
International Journal of Aeronautical and Space Sciences. 15:74-81
This article documents the design of a novel two-loop acceleration autopilot based on L1 adaptive output feedback control for tail-controlled missiles. The inner loop is an adaptive angle-of-attack tracking loop and the outer loop is the traditional
Publikováno v:
Applied Mechanics and Materials. :1833-1836
A remote control system for smart home is designed based on Z-wave, which is divided into two components: controller and receiver. In the controller design, the key signals are scanned by SCM P89LPC9408 to generate and transmit different control comm
Publikováno v:
Advanced Materials Research. 748:723-726
directional antenna is widely used in the measurement and control for Short range UAV because of its high gain in the range of beam angle, the speed of UAV is very fast, so the requirements for speed and acceleration of directional antenna is very hi
Publikováno v:
Applied Mechanics and Materials. :775-779
To manufacture three-dimensional textile composite preform using method of unilateral suture technique, a unilateral suture manipulator system has been designed. In order to inspect whether it can meet the design requirements , this article establish
Autor:
Rong Fu Lin, Yong Chang
Publikováno v:
Advanced Materials Research. 711:506-512
By employing the concepts of support line and support function of the integral geometry, this paper presents an method for analyzing cam mechanisms with a flat-faced follower, including a translating follower, oscillating follower and planar motion f
Autor:
Rong Fu Lin, Yong Chang
Publikováno v:
Applied Mechanics and Materials. :774-779
The offset optimization is one of the key elements of designing cam mechanisms. This paper presents the mechanical model of a disc cam mechanism with an offset translating negative radius roller follower and deduces the efficiency expression. Then it
Publikováno v:
Advanced Materials Research. :4385-4390
An analysis for controlling a static-unstable tactical missile using two-loop acceleration autopilot was detailed. The rate feedback loop was firstly presented. The equivalent actuator dynamics was introduced and examined. Thus an overall stabilizati
Publikováno v:
Advanced Materials Research. :1281-1286
A smart base-isolation system, composed of low damping bearings and piezoelectric friction damper is studied in this paper. The semi-active piezoelectric friction damper (PFD[1]) is proposed for control of peak dynamic response of seismic-excited str