Zobrazeno 1 - 10
of 525
pro vyhledávání: '"Hua Li"'
Publikováno v:
Applied Mechanics and Materials. 858:208-213
Polyvinyl alcohol (PVA) fiber reinforced cementitious material (called PVA-ECC) has been intensively studied as a promising alternative to ordinary cement materials. While PVA-ECC has high stain capacity and ductility, its extreme high cost mainly ca
Publikováno v:
Applied Mechanics and Materials. :184-192
This study presents an experimental investigation of CO2flowing condensation at the saturation temperature of-10°C, mass flux in the range from 40 to 60kgm-2s-1and vapour quality ranging from 0.2 to 0.8, in a 6.52mm inside diameter horizontal tube.
Publikováno v:
Applied Mechanics and Materials. :1347-1351
Diesel particulate filter (DPF) are considered to be the most effective means to reduce particulate emissions, and the key of DPF lies in their regeneration. O3 and O which have strong oxidability can be produced by non-thermal plasma (NTP) reactor.
Publikováno v:
Applied Mechanics and Materials. 779:259-267
In this paper, PV module parameters of dust removal equipment are analyzed; the dust removal device model is established by using solidworks software; the motion simulation of removal process is conducted directly in solidworks motion simulation inte
Autor:
Yun Hua Li, Ran Li
Publikováno v:
Applied Mechanics and Materials. 779:201-204
Mobile robots have been widely used for the good adaptability, payload capability. Robot cooperation brings benefits for the task in a multi-robot team. In this paper, the modular hardware design of a leader-follower mobile robot team is discussed, i
Publikováno v:
Applied Mechanics and Materials. 768:402-405
A new method to make SMA is developed by using SBS modified asphalt when the coarse aggregate steel slag and the fine basalt aggregate are selected respectively. The Mix Proportion is 1#(16-9.5mm, steel slag):2#(9.5-4.75mm, steel slag):3#(3-4.75mm, b
Publikováno v:
Applied Mechanics and Materials. :128-133
Characteristics of a water-cooled non-thermal plasma (NTP) reactor used to reduce diesel emissions were experimentally studied. The effects of working voltage, operating frequency and air flow rate on discharge power and concentrations of O3 and NO2
Publikováno v:
Applied Mechanics and Materials. 751:66-71
The Cu/Zn-14.1Al-0.9Si/Al joints were joined by flame brazing and furnace brazing, respectively. The influence of brazing methods on the interface structure and property of Cu/Al brazed joint was investigated. It was found that the interface structur
Publikováno v:
Applied Mechanics and Materials. 751:61-65
Based on the difficulty to accurately control temperature for torch brazing, the study is concerned with developing low-melting-point solders for brazing pure aluminum. For this purpose, Ge and Zn have been chosen to be added to Al-Si-based alloy. Th
Publikováno v:
Applied Mechanics and Materials. :666-669
The Candide face model and the Face Action Coding System (FACS) are introduced in the paper. The relations of the positions of feature points of Candide-3 model and the action units of FACS are studied. The application system for computing the facial